![]() The router/wap should have an ethernet port (beyond the 4 above) > My isp cablevision/optonline provides a modem with a wired ethernet > Hence an /etc/hosts file lets each machine access the others by name > firmware did not let me set specific dhcp addresses for specific > * I am actually running the so-called "tomato firmware". dhcp (with settable addresses see below*) Wireless access point 802.11 b/g (n would be nice a ok) >= 4 wired ethernet ports for systems/devices (at least 1 port 1Gig) > I should upgrade even if the "funny" turns out to be just a config error > Since my new laptop supports 1Gig wired ethernet and the wrt is 100Meg, > I have a linksys wrt54G that is acting a little funny. Then, if you are in a crowded (rf wise) environment, have an old 802.11b (10Mb) device in range and the antennas are more than few meters apart, someone is cooking dinner in the microwave. Add to that most wifi speeds on the box come from the marketing department. Think overhead for encryption, error recovery, and speed reduction for distance. ![]() You can expect best case of 50% thru put for wifi (I.e., 50Mbs), and usually much less. To accept the modem output (I realize it is all bidirectional). My isp cablevision/optonline provides a modem with a wired ethernet Hence an /etc/hosts file lets each machine access the others by name The stdįirmware did not let me set specific dhcp addresses for specific * I am actually running the so-called "tomato firmware". Wireless access point 802.11 b/g (n would be nice a ok)ģ. >= 4 wired ethernet ports for systems/devices (at least 1 port 1Gig)Ģ. I should upgrade even if the "funny" turns out to be just a config errorġ. Since my new laptop supports 1Gig wired ethernet and the wrt is 100Meg, I have a linksys wrt54G that is acting a little funny.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |